- Notes, cautions, and warnings
- Revision history
- Introduction
- Configurations and features
- Initial setup and configuration
- Pre-operating system management applications
- Manage the pre-operating system applications
- Set up the system
- Configure system BIOS settings
- Configure system Information
- Configure memory settings
- Configure the processor
- Set the NVMe drive mode
- Configure the boot mode
- Configure network settings
- Configure integrated devices
- Configure serial communication
- Configure the system profile
- System security overview
- Configure redundant operating system control
- View miscellaneous settings
- iDRAC and device settings
- Configure system BIOS settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Set up the system
- iDRAC configuration
- Manage the pre-operating system applications
- Minimum configuration to POST
- Technical specifications
- Component replacement guidelines
- Jumpers and connectors
- Use system diagnostics
Dell VxRail VD-4510c Hardware Requirements and Specifications
Supported hardware components
Refer to the online support website or SolVe Online for VxRail for hardware-specific information.
The following table contains the not exhaustive list of FRU and CRU components:
| Hardware Components | Customer Replaceable Unit (CRU) | Field Replaceable Unit (FRU) |
|---|---|---|
| M.2 NVMe SSD | Yes | No |
| Sled cover | Yes | No |
| BOSS-N1 card | Yes | No |
| Fan assembly | Yes | No |
| System board | No | Yes |
| System memory | Yes | No |
| System battery | Yes | No |
| Network I/O board | Yes | No |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\