- Notes, cautions, and warnings
- Revision history
- Introduction
- Configurations and features
- Initial setup and configuration
- Pre-operating system management applications
- Manage the pre-operating system applications
- Set up the system
- Configure system BIOS settings
- Configure system Information
- Configure memory settings
- Configure the processor
- Set the NVMe drive mode
- Configure the boot mode
- Configure network settings
- Configure integrated devices
- Configure serial communication
- Configure the system profile
- System security overview
- Configure redundant operating system control
- View miscellaneous settings
- iDRAC and device settings
- Configure system BIOS settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Set up the system
- iDRAC configuration
- Manage the pre-operating system applications
- Minimum configuration to POST
- Technical specifications
- Component replacement guidelines
- Jumpers and connectors
- Use system diagnostics
Dell VxRail VD-4510c Hardware Requirements and Specifications
Technical specifications
This section outlines the technical and environmental specifications of your VxRail.
The VxRail VD-4510c compute sled supports the processor, battery, storage controller, and drive specifications:
| Component | Specification |
|---|---|
| Processor | One Third Generation Intel Xeon D Scalable processor with up to 16 cores |
| Battery | CR 2032 3.0-V Lithium coin cell system battery |
| Storage controller | Boot Optimized Storage Subsystem (BOSS-N1): 2 x M.2 SSD as internal boot |
| Drives | 4 x M.2 SSDs (M.2 2280 and M.2 22110) installed on M.2 riser module and one disk group configuration with 1 cache drive and up to 3 capacity drives |
The VxRail VD-4510c supports the following memory specifications for optimized operation:
| DIMM type | DIMM rank | DIMM capacity | Single processor | |
|---|---|---|---|---|
| Minimum system capacity | Maximum system capacity | |||
| RDIMM | Dual rank | 16 GB | 16 GB | 64 GB |
| 32 GB | 32 GB | 128 GB | ||
| 64 GB | 64 GB | 256 GB | ||
| LRDIMM | Quad rank | 128 GB | 128 GB | 512 GB |
The VxRail VD-4510c supports four 288-pin memory module sockets that operate at a speed of 3200 MT/s.
NOTE:Memory DIMM slots are not hot swappable.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\