- Notes, cautions, and warnings
- Revision history
- Introduction
- Configurations and features
- Initial setup and configuration
- Pre-operating system management applications
- Manage the pre-operating system applications
- Set up the system
- Configure system BIOS settings
- Configure system Information
- Configure memory settings
- Configure the processor
- Set the NVMe drive mode
- Configure the boot mode
- Configure network settings
- Configure integrated devices
- Configure serial communication
- Configure the system profile
- System security overview
- Configure redundant operating system control
- View miscellaneous settings
- iDRAC and device settings
- Configure system BIOS settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Set up the system
- iDRAC configuration
- Manage the pre-operating system applications
- Minimum configuration to POST
- Technical specifications
- Component replacement guidelines
- Jumpers and connectors
- Use system diagnostics
Dell VxRail VD-4510c Hardware Requirements and Specifications
Set the NVMe drive mode
If the system contains NVMe drives that you want to configure in a RAID array, you must set both this field and the Embedded SATA field on the SATA settings menu to RAID Mode. You may also need to change the Boot Mode setting to UEFI.
- To view the NVMe Settings screen, power on the system, and press F2.
- Click .
- Use the following table to set the NVMe drive mode:
Option Description NVMe mode Enables or disables the boot mode. The option is set to Non-RAID mode by default. BIOS NVMe Driver Sets the drive type to boot the NVMe driver. The available options are Dell Qualified Drives (default) and All Drives.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\