- Notes, cautions, and warnings
- Revision history
- Introduction
- Configurations and features
- Initial setup and configuration
- Pre-operating system management applications
- Manage the pre-operating system applications
- Set up the system
- Configure system BIOS settings
- Configure system Information
- Configure memory settings
- Configure the processor
- Set the NVMe drive mode
- Configure the boot mode
- Configure network settings
- Configure integrated devices
- Configure serial communication
- Configure the system profile
- System security overview
- Configure redundant operating system control
- View miscellaneous settings
- iDRAC and device settings
- Configure system BIOS settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Set up the system
- iDRAC configuration
- Manage the pre-operating system applications
- Minimum configuration to POST
- Technical specifications
- Component replacement guidelines
- Jumpers and connectors
- Use system diagnostics
Dell VxRail VD-4510c Hardware Requirements and Specifications
Ports and connectors specifications
Specifications for the USB, NIC, serial connector, display, and iDRAC9 ports are provided.
The following table shows the USB specifications of VxRail VD-4510c:
| Front | Internal (optional) | ||
|---|---|---|---|
| USB port type | Ports | USB port type | Ports |
| USB 3.0-compliant port | Two | Internal USB 3.0-compliant port | One |
| Micro-AB USB 2.0-compliant port for iDRAC Direct | One | ||
The VxRail VD-4510c supports the following:
- Up to four NIC ports embedded on the LOM card. The LOM card specifications are: 10 GbE x 4 (max 50 Gb), 25 GbE x 4 (max 100 Gb).
- One Micro-USB debug port for Universal Asynchronous Receiver or Transmitter (UART) in front of the compute sled.
- One Mini-DisplayPort on the front.
- One RJ45 with port status LEDs for iDRAC9 remote management (dedicated port only) in the front.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\