Zu den Hauptinhalten

Dell OpenManage Deployment Toolkit Version 4.3 Command Line Interface Reference Guide

PDF

pefcfgparams

Table 1. pefcfgparams options
Option	Sub-option	Valid Arguments	Description	Applicable Systems
`pefcfgparams or pcp`			Configures and displays PEF configuration parameters. This option can be replicated.	All PowerEdge systems
	`--filter`	`fanfail, voltfail, discretevoltfail, tempwarn, tempfail, intrusion, redundegraded,redunlost, procwarn, procfail, powerwarn, powerfail, hardwarelogfail, autorecovery, batterywarn, batteryfail, powerabsent, procabsent, systempowerwarn, systempowerfail`	Specifies a PEF value. This sub-option can be replicated. For a complete list of all possible PEF messages along a description of each event, see BMC Platform Events Filter Alert Messages NOTE: The `fanfail` option is not supported on PowerEdge 10G systems.
	`--filteraction`	`powercycle, reset, powerdown, power reduction, none`	Sets the event filter action for the filter specified using the `filter` sub-option. This sub-option depends on the `filter` sub-option. This sub-option can be replicated.
	`--hostname`	`< string>`	Sets the host name (maximum of 62 printable ASCII characters) for the BMC. This sub-option can be replicated. The `hostname` string must comprise only the followig characters: hyphen (-) , underscore (_) , and period (.) . The length of the `hostname` string must be 62 characters or less for PowerEdge 9G systems and later.
	`--filteralert`	`enable, disable`	Enables or disables alerts for the filter specified using the filter sub-option. This sub-option is dependent on the filter sub-option. This sub-option can be replicated.
	`--alertpolnum`	`1, 2, 3, 4`	Specifies the alert policy entry number. This sub-option can be replicated.
	`--alertpolstatus`	`enable, disable`	Enables or disables the alert policy specified using the `alertpolnum` sub-option. This sub-option can be replicated. This sub-option is dependent on the `alertpolnum` sub-option. Example: (to set the PEF configuration parameters): Example 1 (To configure the PEF so that the system is powered down in response to a fan failure event): A:>syscfg pefcfgparams --filter= fanfail--filteraction=powerdown pefcfgparams filter=fanfail filteraction=powerdown Example 2 (To configure the PEF so that a PEF alert is not sent to the destination IP address in response to a chassis intrusion event): A:>syscfg pefcfgparams --filter= intrusion--filteralert=disable pefcfgparams filter= intrusion filteralert=disable