Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

Description

Runs a power action on the chassis or a switch.

To use this subcommand, you must have the Chassis Control Administrator privilege.

Synopsis

Input

• -m <module> — Module on which you want to carry out the action. Values are:
  • chassis — this is the default value, if -m is not specified.
  • switch-n, where n=1

• <action> — Action that you want to run on the specified module. Values are:
  • powerdown — (Chassis only) Turns off the chassis.
  • powerup — (Chassis only) Turns on the chassis.
  • powercycle — Power cycles the module.
  • nongraceshutdown — (Chassis only) Non-gracefully turns off the chassis.
  • reset — Performs a hard reset of the module.

When <module> = switch, <action> must be powercycle or reset.

Output

None

Example

Perform a reset of switch-1:

racadm chassisaction -m switch-1 reset

Module power operation successful.