Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

Description

Sets the iDRAC IP address. It displays an error message if the requested operation could not be performed, or a success message, if the operation is completed successfully.

To use this subcommand, you must have the Configure iDRAC privilege.

Synopsis

• racadm setniccfg -d

• racadm setniccfg -d6

• racadm setniccfg -s <IPv4Address> <netmask> <IPv4 gateway>

• racadm setniccfg -s6 <IPv6 Address> <IPv6 Prefix Length> <IPv6 Gateway>

• racadm setniccfg -o

Input

• -d — Enables DHCP for the NIC (default is “DHCP disabled”.)
• -d6 — Enables AutoConfig for the NIC. It is enabled by default.
• -s — Enables static IP settings. The IPv4 address, netmask, and gateway can be specified. Otherwise, the existing static settings are used. <IPv4Address>, <netmask>, and <gateway> must be typed as dot-separated strings.

  racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• -s6 — Enables static IPv6 settings. The IPv6 address, Prefix Length, and the IPv6 gateway can be specified.
• -o — Enable or disable NIC.

Example

• racadm setniccfg -s 192.168.0.120 255.255.255.0 192.168.0.1

• racadm setniccfg -d

• racadm setniccfg -d6