Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

racadm ?

racadm ? <subcommand>

Example for RACADM ?

The following output example shows only part of the actual output for the racadm ? command. Descriptions shown in this example may vary slightly from the descriptions in your racadm session.

racadm ?

help            -- list racadm subcommand description
help <subcommand> -- display usage summary for a subcommand
?               -- list racadm subcommand description
? <subcommand>  -- display usage summary for a subcommand
arp             -- display the networking arp table
chassisaction   -- execute chassis or switch power-up/down/cycle or
KVM powercycle
clrraclog       -- clear the CMC log
clrsel          -- clear the System Event Log (SEL)
cmcchangeover   -- Changes the redundant state of the CMC from active
to standby and vice versa
config          -- modify CMC configuration properties
...
setniccfg       -- modify network configuration properties
setractime      -- set the time on the CMC
setslotname     -- sets the name of the slot in the chassis
setsysinfo      -- set the chassis name and chassis location
sslcertview     -- display a CA/server certificate in the CMC
sslcsrgen       -- generate a certificate CSR from the CMC
testemail       -- test CMC e-mail notifications
testfeature     -- test CMC feature x
testtrap        -- test CMC SNMP trap notifications
traceroute      -- determine the route of a packet
traceroute6     -- determine the route of a packet

Example for RACADM ? <subcommand>

racadm ? getsysinfo

getsysinfo -- display general CMC and system information
Usage:
racadm getsysinfo [-d] [-c] [-A] [-4] [-6]
-----------------------------------------------------------
Valid Options:
-d : show CMC information
-c : show chassis information
-A : do not show headers or labels
-4 : show CMC IPv4 information
-6 : show CMC IPv6 information