Dell Chassis Management Controller Version 3.0 for PowerEdge VRTX RACADM CLI Guide

racadm racresetcfg [-m <module>] [-c <feature>]

• -m : <module> — Must be one of the following values:
  • chassis — default state, if -m is not specified.
  • server-n, where n=1–4

  • switch-n, where n=1

• -c : <feature> — Must be one of the following values:
  • ad — Reset Active Directory properties to the default value. The default setting is “disabled”.
  • pcap — Reset Power Cap properties to the default value.
  • flex — Reset FlexAddress properties to the default value. The default setting is “enabled”.
  • dpse — Reset Dynamic Power Supply Engagement to the default value. The default setting is “disabled”.
    NOTE The –c option is valid with only <module=chassis>.

• Perform reset of configuration data to defaults for server-1 module

  racadm racresetcfg -m server-1

• Perform reset of power cap feature.

  racadm racresetcfg -c pcap

• Perform reset of configuration data to default for switch-1 module

  racadm racresetcfg -m switch-1