- Notes, cautions, and warnings
- About this document
- System overview
- Initial system setup and configuration
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- Optional front bezel
- System cover
- Drive backplane cover
- Control panel
- VGA module
- Air shroud
- Cooling fan
- Drives
- Drive backplane
- Cable routing
- Rear drive module
- Front PERC module
- System memory
- Processor and heat sink
- Expansion cards and expansion card risers
- Optional serial COM port
- Optional IDSDM module
- MicroSD card
- M.2 SSD module on BOSS-S1 adapter card
- BOSS S2 card (optional)
- System battery
- Optional internal USB card
- Intrusion switch module
- Optional OCP card
- Power supply unit
- Trusted Platform Module
- System board
- LOM card and rear I/O board
- RIO card
- Tube clip
- Upgrade Kits
- Jumpers and connectors
- System diagnostics and indicator codes
- Known Issue
- Getting help
- Documentation resources
Dell PowerEdge R6525 Installation and Service Manual
Downloading drivers and firmware
It is recommended that you download and install the latest BIOS, drivers, and systems management firmware on the system.
Prerequisites
Steps
- Go to www.dell.com/support/drivers.
-
Enter the Service Tag of the system in the
Enter a Dell Service Tag, Dell EMC Product ID or Model field, and then press Enter.
NOTE:If you do not have the Service Tag, select Detect PC to automatically detect the Service Tag, or click Browse all products, and navigate to your product.
-
On the displayed product page, click
Drivers & Downloads.
On the Drivers & Downloads page, all drivers that are applicable to the system are displayed.
- Download the drivers to a USB drive, CD, DVD or local machine.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\