Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Installing the rear drive module

Prerequisites

  1. Follow the safety guidelines listed in Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the air shroud.

Steps

  1. Align the rear drive module with the guide on the system board.
  2. Lower the rear drive module and slide till it clicks.
  3. Using a Phillips #1 screwdriver, tighten the captive screws on the rear drive module.
    Figure 1. Installing the rear drive module

    This image shows Installing the rear drive module.

    Figure 2. Installing the liquid cooling rear drive module
    This image shows the installation of the liquid cooling rear drive module

Next steps

  1. If removed, install the expansion card riser 3.
  2. Connect all the cables to the rear drive module.
  3. Install the rear drives.
  4. Install the air shroud.
  5. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\