Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Installing the air shroud

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align the slot on the air shroud with the standoff on the system.
  2. Lower the air shroud into the system until it is firmly seated.
    NOTE:The air shroud is required for the standard heat sink configuration. For the L-type heat sink configuration, air shroud is not supported.
    Figure 1. Installing the air shroud
    This shows how to install the air shroud.
  3. For the air shroud on the rear drive module, lower the air shroud into the rear drive module until it is firmly seated.
    Figure 2. Installing the air shroud on the rear drive module

    Installing the air shroud on the rear drive module

Next steps

  1. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\