Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Installing the rear mounting front PERC module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. Remove the drive backplane cover.
  4. If installed, remove the air shroud.
  5. Remove the drive backplane.
  6. Route the cable properly to prevent the cable from being pinched or crimped.

Steps

  1. Align the connectors on the front PERC module with the connectors on the drive backplane.
  2. Slide the front PERC module until the module is connected to the drive backplane.
  3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Installing the rear mounting front PERC module
    This image shows how to install the rear mounting front PERC module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\