Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Installing the RIO card

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the system board.
  4. If required, remove the LOM card.
    NOTE:Upgrading the system board with the liquid cooling solution requires the LOM card to be replaced with the RIO card.

Steps

  1. Align the connectors and slots on RIO card with the connector and standoffs on the system board.
  2. Press the RIO card until firmly seated on the system board connector.
  3. Using a Phillips #2 screwdriver, secure the RIO card to the system board with the two screws.
    Figure 1. Installing the RIO card
    This image shows how to install the RIO card

Next steps

  1. Install the system board.
  2. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\