Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Removing the right control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the drive backplane cover.
  4. If installed, remove the air shroud.

Steps

  1. Disconnect the right control panel cable from the connector on the system board.
  2. Lift the latch, and slide the cable out of the clip.
    NOTE:Observe the routing of the cable as you remove the right control panel from the system.
  3. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel to the system.
  4. Holding the cable, slide the right control panel out of the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the right control panel
    This image shows how to remove the right control panel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\