Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Installing the left control panel

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.

Steps

  1. Align and slide the left control panel in the slot on the system.
  2. Connect the left control panel cable to the connector on the system board and secure it using cable latch.
  3. Route the left control panel cable through the side wall of the system and slide the cable into the clip.
    NOTE:Route the cable properly to prevent the cable from being pinched or crimped.
  4. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel to the system.
    Figure 1. Installing the left control panel
    This image shows how to install the left control panel.

Next steps

  1. Install the drive backplane cover.
  2. If removed, install the air shroud.
  3. Follow the procedure listed in After working inside your system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\