Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Installing the drive into the drive carrier

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. If installed, remove the front bezel.
  3. Remove the drive blank.

Steps

  1. Insert the drive into the drive carrier with the drive connector facing towards the rear of the carrier.
  2. Align the screw holes on the drive with the screws holes on the drive carrier.
  3. Using a Phillips #1 screwdriver, secure the drive to the drive carrier with the screws.
    NOTE:When installing a drive into the drive carrier, ensure that the screws are torqued to 4 lbf-in.
    NOTE: If the hard drive or SSD carrier has Torx screw, use Torx 6 (for 2.5-inch drive) or Torx 8 (for 3.5-inch drive) screwdriver to install the drive.
    Torx screw image
    Figure 1. Installing a drive into the drive carrier
    This image shows installing a drive into the drive carrier

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\