Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Removing expansion card from the expansion card riser

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. If applicable, disconnect the cables from the expansion card.

Steps

  1. Pull and lift the expansion card retention latch lock to open.
    NOTE:Pull the black card holder before removing the card from the riser.
    Figure 1. Opening the card holder on the expansion card riser
    This image shows how to open the card holder.
  2. Hold the expansion card by the edges and pull the card until the card edge connector disengages from the expansion card connector on the riser.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 2. Removing expansion card from the expansion card riser
    This image shows how to remove expansion card from the expansion card riser.
  3. If the expansion card is not going to be replaced, install a filler bracket and close the card retention latch.
    Figure 3. Installing the filler bracket
    This image shows how to install a filler bracket into the expansion card riser.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\