Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Baskets

Dell PowerEdge R6525 Installation and Service Manual

PDF

Removing the VGA module

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. If installed, remove the front bezel.
  4. Remove the backplane cover.
  5. If installed, remove the air shroud.
  6. Disconnect the VGA cable from the connector on the system board and open the cable latch.
  7. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the system.
NOTE:Ensure that you note the routing of the cables as you remove them from the system board. Route the cable properly when you replace it to prevent the cable from being pinched or crimped

Steps

  1. Using Phillips #2 screwdriver, remove the screw on the VGA module.
  2. Slide the VGA module out of the system.
    NOTE:The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
    Figure 1. Removing the VGA module
    This image shows how to remove the VGA module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\