Dell G15 5530 Owner's Manual

PDF

Installing the rear cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the rear cover and provides a visual representation of the installation procedure.

Image: Replacing the rear cover

Steps

  1. Slide the rear cover towards the system board till it snaps into place.
  2. Align the screw holes on the rear cover with the screw holes on the palm-rest and keyboard assembly.
  3. Replace the four screws (M2x5) that secure the rear cover to the system board.
  4. Replace the two screws (M2x4) that secure the rear cover to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\