Dell G15 5530 Owner's Manual

PDF

Removing the palm-rest and keyboard assembly

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.
  3. Remove the battery.
  4. Remove the rear cover.
  5. Remove the touchpad.
  6. Remove the display assembly.
  7. Remove the solid-state drive.
  8. Remove the wireless card.
  9. Remove the memory module.
  10. Remove the speakers.
  11. Remove the power adapter port.
  12. Remove the system board.
    NOTE: The system board can be removed as an assembly with the fan and heat-sink assembly, Ethernet and audio board, and USB board attached.
  13. Remove the keyboard-controller board, if applicable.
  14. Remove the power-button assembly.

About this task

After performing the steps in the pre-requisites, we are left with the palm-rest and keyboard assembly.

Image: Palm-rest and keyboard assembly
NOTE:When replacing the palm-rest and keyboard assembly, the solid-state drive screw mount must be removed from the existing palm-rest and keyboard assembly and transferred to the replacement palm-rest and keyboard assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\