Dell G15 5530 Owner's Manual

PDF

Installing the wireless card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the wireless card and provides a visual representation of the installation procedure.

Image: Installing the wireless card

Steps

  1. Connect the antenna cables to the wireless card.

    The following table provides the antenna-cable color scheme for the wireless card supported by your computer.

    Table 1. Antenna-cable color schemeThe table describes the antenna-cable color scheme.
    Connectors on the wireless card Antenna-cable color
    Main (white triangle) White
    Auxiliary (black triangle) Black
  2. Align the notch on the wireless card with the tab on the M.2 wireless card slot and insert the wireless card at an angle into the M.2 card slot.
  3. Place and align the wireless-card bracket on the wireless card.
  4. Replace the screw (M2x4) that secures the wireless card to the system board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\