You can configure default settings for replication policies. If you do not modify these settings when creating a replication policy, the specified default settings are applied.
Click
Data Protection > SyncIQ > Settings.
In the
Default Policy Settings section, if you want policies to connect only to nodes in a specified SmartConnect zone, select
Connect only to the nodes within the target cluster SmartConnect zone.
NOTE:This option will affect only policies that specify the target cluster as a SmartConnect zone.
Specify which nodes you want replication policies to connect to when a policy is run.
Option
Description
To connect policies to all nodes on a source cluster:
Click
Run the policy on all nodes in this cluster.
To connect policies only to nodes contained in a specified subnet and pool:
Click
Run the policy only on nodes in the specified subnet and pool.
From the
Subnet and pool list, select the subnet and pool .
NOTE:SyncIQ does not support dynamically allocated IP address pools. If a replication job connects to a dynamically allocated IP address, SmartConnect might reassign the address while a replication job is running, which would disconnect the job and cause it to fail.
Click
Save Changes.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\