- Notes, cautions, and warnings
- Introduction to this guide
- OneFS backup and recovery
- Data replication with SyncIQ
- Protecting data with SyncIQ
- Creating replication policies
- Managing replication to remote clusters
- Managing replication policies
- Managing replication to the local cluster
- Managing replication performance rules
- Managing replication reports
- Managing failed replication jobs
- Managing changelists
- Configuring SyncIQ Failover/Failback Policies
- NDMP backup and recovery
- NDMP backup and restore models overview
- NDMP two-way backup
- NDMP three-way backup
- Support for NDMP sessions on Generation 6 hardware
- Setting preferred IPs for NDMP three-way operations
- NDMP multi-stream backup and recovery
- NDMP file list backup overview
- Snapshot-based incremental backups
- NDMP backup and restore of SmartLink files
- NDMP protocol support
- Supported DMAs
- NDMP hardware support
- Sharing tape drives between clusters
- NDMP backup limitations
- NDMP performance recommendations
- Excluding files and directories from NDMP backups
- Administering NDMP
- NDMP backup and recovery tasks
- Configuring basic NDMP backup settings
- Managing NDMP user accounts
- Managing NDMP environment variables
- Managing NDMP contexts
- Managing NDMP sessions
- Managing NDMP Fibre Channel ports
- Managing NDMP preferred IP settings
- Managing NDMP backup devices
- NDMP dumpdates file overview
- Managing snapshot based incremental backups
- NDMP restore operations
- Managing file list backups
- Managing cluster performance for NDMP sessions
- Managing CPU usage for NDMP sessions
- Configuring NDMP backups with NetWorker
- Configuring NDMP backup with Veritas NetBackup
- Configuring NDMP backup with CommVault Simpana
- Configuring NDMP backup with IBM Tivoli Storage Manager
- Sparse file support
PowerScale OneFS 9.8.0.0 Backup and Recovery Guide
Configuring NDMP backups with NetWorker
You can configure OneFS and NetWorker to backup data stored on an PowerScale cluster. The following procedures explain how to configure NDMP backup with NetWorker 9.0.
NOTE:The steps described in the procedures are general guidelines only. They might change for different versions of NetWorker. Consult your DMA vendor documentation for the configuration information for a specific version of NetWorker.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\