OneFS creates a device entry for each device that you attach to the cluster through a Fiber Attached Storage node.
The following table describes the settings that you can review for an added tape or media changer device in the
Devices table and also through the
View Tape Devices dialog box that appears when you select a device and click
View/Edit:
Table 1. Backup Device SettingsThe following table describes each setting.
Setting
Description
Name
Specifies a device name that is assigned by
OneFS.
State
Indicates whether the device is in use. If data is being backed up to or restored from the device,
Read/Write appears. If the device is not in use,
Closed appears.
WWNN
Specifies the worldwide node name of the device.
Product (Vendor/Model/Revision)
Specifies the name of the device vendor and the model name or number of the device.
Serial Number
Specifies the serial number of the device.
Actions
Allows you to view, edit, or delete a device.
Path
Specifies the name of the Fiber Attached Storage node that is attached to the device and the port numbers to which the device is connected.
LUN
Specifies the logical unit number (LUN) of the device.
State
Specifies whether the device is active or inactive.
WWPN
Specifies the worldwide port name (WWPN) of the port on the tape or media changer device.
Port ID
Specifies the port ID of the device that binds the logical device to the physical device.
Open Count
A counter of the active and open connections to the device.
Device Name
Specifies the regular device name that appears under the FreeBSD operating system.
Pass Name
Specifies the pass-through device name that appears under the FreeBSD operating system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\