- Notes, cautions, and warnings
- Introduction to this guide
- OneFS backup and recovery
- Data replication with SyncIQ
- Protecting data with SyncIQ
- Creating replication policies
- Managing replication to remote clusters
- Managing replication policies
- Managing replication to the local cluster
- Managing replication performance rules
- Managing replication reports
- Managing failed replication jobs
- Managing changelists
- Configuring SyncIQ Failover/Failback Policies
- NDMP backup and recovery
- NDMP backup and restore models overview
- NDMP two-way backup
- NDMP three-way backup
- Support for NDMP sessions on Generation 6 hardware
- Setting preferred IPs for NDMP three-way operations
- NDMP multi-stream backup and recovery
- NDMP file list backup overview
- Snapshot-based incremental backups
- NDMP backup and restore of SmartLink files
- NDMP protocol support
- Supported DMAs
- NDMP hardware support
- Sharing tape drives between clusters
- NDMP backup limitations
- NDMP performance recommendations
- Excluding files and directories from NDMP backups
- Administering NDMP
- NDMP backup and recovery tasks
- Configuring basic NDMP backup settings
- Managing NDMP user accounts
- Managing NDMP environment variables
- Managing NDMP contexts
- Managing NDMP sessions
- Managing NDMP Fibre Channel ports
- Managing NDMP preferred IP settings
- Managing NDMP backup devices
- NDMP dumpdates file overview
- Managing snapshot based incremental backups
- NDMP restore operations
- Managing file list backups
- Managing cluster performance for NDMP sessions
- Managing CPU usage for NDMP sessions
- Configuring NDMP backups with NetWorker
- Configuring NDMP backup with Veritas NetBackup
- Configuring NDMP backup with CommVault Simpana
- Configuring NDMP backup with IBM Tivoli Storage Manager
- Sparse file support
PowerScale OneFS 9.8.0.0 Backup and Recovery Guide
Installing the optional 2x10GbE + 2x8GB Fibre Channel NIC cards
Install the optional 2x10GbE + 2x8GB Fibre Channel NICs in a paired configuration. On any chassis where you install a 2x10GbE + 2x8GB Fibre Channel NIC, install either two or four cards in the chassis. The optional 2x10GbE + 2x8GB Fibre Channel NIC replaces the front-end Ethernet NIC with a hybrid 4-port (2x10GbE and 2xFC) NIC or HBA to support simultaneous traffic coming in both through either port.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\