PowerScale OneFS 9.8.0.0 Backup and Recovery Guide

Label tape devices

With NetWorker, you must label tape devices attached to an PowerScale cluster before you can back up data to these devices.

1. Connect to the NetWorker server from the NetWorker Management Console Server.
2. On the Enterprise tab, select a NetWorker server name and double-click.
3. Click Launch NetWorker Administration.
4. In the NetWorker administration window, click Devices.
5. Click the name of the library that you configured.
6. In the device list, highlight all the tape drives that you want to label.
7. Right-click the highlighted list, and then click Label.
8. In the Label Library Media window, from the Target Media Pool list, select the name of the media pool you created.
9. Make sure that the Prompt to Overwrite Existing Label box is cleared.
10. Click OK.