- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- Stand
- Optical drive
- Side Cover
- Intrusion switch
- System board shield
- Hard drive
- Cable holder
- Memory modules
- Coin-cell battery
- Solid State Drive
- WLAN card
- Heat sink
- System fan
- Power and On-Screen Display
- Speaker
- VGA/Serial port (optional)
- Processor
- System board
- Chassis frame
- Display assembly
- Camera
- M.2 Intel Optane Memory Module 16 GB
- Technology and components
- System setup
- Technical specifications
- Processor specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Cards specifications
- Display specifications
- Drives specifications
- Port and connector specifications
- Power specifications
- Camera specifications
- Stand specifications
- Physical specifications
- Environmental specifications
- Troubleshooting
- Contacting Dell
Dell OptiPlex 3050 All-in-One Owners Manual
Installing memory module
- Insert the memory module into the slot and then press down until the clips snap-in.
- Perform the same steps to insert the second memory module.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\