OptiPlex 3080 Small Form Factor Service Manual

PDF

Installing the 2.5 in. hard drive assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the 2.5 in. hard drive and provides a visual representation of the installation procedure.

Steps

  1. Insert the hard drive assembly into the slot on the system and slide the hard drive assembly down.
  2. Press down the hard drive assembly, until it clicks into place.
  3. Replace the 6-32 screw to fix the hard drive assembly.
  4. Connect the power cable and hard drive cable to the connectors on the hard drive.

Next steps

  1. Install the front bezel.
  2. Install the side cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\