OptiPlex 3080 Small Form Factor Service Manual

PDF

Removing the M.2 2280 PCIe solid-state drive

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the side cover.
  3. Remove the front bezel.
  4. Remove the 2.5 in. hard drive assembly.

About this task

The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.

Steps

  1. Remove the screw (M2x3) that secures the solid-state drive to the system board.
  2. Slide and lift the solid-state drive off the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\