OptiPlex 3080 Small Form Factor Service Manual

PDF

Removing optional I/O modules (Type C/ HDMI/VGA/DP/Serial)

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the side cover.
  3. Remove the front bezel.
  4. Remove the chassis fan.
  5. Remove the fan duct.

About this task

The following images indicate the location of the optional I/O Modules and provides a visual representation of the removal procedure.

Steps

  1. Remove the two (M3X3) screws that secure the optional i/O module to the computer chassis.
  2. Disconnect the I/O-module cable from the connector on the system board.
  3. Remove the I/O module from the computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\