OptiPlex 3080 Small Form Factor Service Manual

PDF

Installing the WLAN card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the wireless card and provides a visual representation of the installation procedure.

Installing the WLAN card

Steps

  1. Connect the antenna cables to the WLAN card.
    The following table provides the antenna-cable color scheme for the WLAN card of your computer.
    Table 1. Antenna-cable color schemeThe table provides the antenna-cable color scheme for the WLAN card:
    Connectors on the wireless card Antenna-cable color
    Main (white triangle) White
    Auxiliary (black triangle) Black
  2. Place the WLAN card bracket to secure the WLAN cables.
  3. Insert the WLAN card into the connector on the system board.
  4. Replace the (M2x3) screw to secure the plastic tab to the WLAN card.

Next steps

  1. Install the 2.5 in. hard drive assembly.
  2. Install the front bezel.
  3. Install the side cover.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\