OptiPlex 3080 Small Form Factor Service Manual

PDF

Installing the memory modules

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the memory modules and provides a visual representation of the installation procedure.

Steps

  1. Align the notch on the memory module with the tab on the memory-module slot.
  2. Slide the memory module firmly into the slot at an angle and press the memory module down until it clicks into place.
    NOTE:If you do not hear the click, remove the memory module and reinstall it.

Next steps

  1. Install the 2.5 in. hard drive assembly.
  2. Install the front bezel.
  3. Install the side cover.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\