OptiPlex 3080 Small Form Factor Service Manual

PDF

Installing the intrusion switch

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the intrusion switch and provides a visual representation of the installation procedure.

Install intrusion switch

Steps

  1. Insert the intrusion switch into its slot and slide the switch to secure it into the slot.
  2. Connect the intruder cable to the connector on the system board.

Next steps

  1. Install the fan duct.
  2. Install the side cover.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\