OptiPlex 3080 Small Form Factor Service Manual

PDF

Installing the graphics card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following image indicates the location of the graphics card and provides a visual representation of the installation procedure.

Steps

  1. Align the expansion card with the connector on the system board.
  2. Place the card in the connector and press down firmly. Ensure that the card is firmly seated.
  3. Close the expansion card latch and press it until it clicks into place.

Next steps

  1. Install the Side cover
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\