Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Precision 3480 Owner's Manual

Installing the battery

CAUTION:The information in this section is intended for authorized service technicians only.

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.

Figure 1. Installing the battery
Image: Installing the battery

Steps

  1. Using the alignment posts, place the battery on the palm-rest assembly.
  2. Align the screw holes on the battery with the screw holes on the palm-rest assembly.
  3. Tighten the five captive screws that secure the battery to the palm-rest assembly.
  4. Connect the battery cable to the system board.
  5. Adhere the tape that secures the battery cable to the battery.

Next steps

  1. Install the base cover.
  2. Install the nanoSIM card.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\