CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display panel and provide a visual representation of the installation procedure.
Figure 1. Installing the display panel
Steps
Connect the display cable to the connector on the display panel and close the latch to secure the cable.
Adhere the tape that secures the display cable to the display panel.
Close the display panel and the display back cover to assemble.
NOTE:Ensure that the display panel tabs are inserted into the slots on the display cover.
Replace the two screws (M2.5x3) to secure the display panel to the display back cover.
