CAUTION:The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following images indicate the location of the display hinges and provide a visual representation of the installation procedure.
Figure 1. Installing the display hinges
Steps
Align the screw hole on the left hinge with the screw hole on the display back cover.
Replace the two screws (M2.5x3) to secure the left hinge to the display back cover.
Align the screw hole on the right hinge with the screw hole on the display back cover.
Replace the two screws (M2.5x3) to secure the right hinge to the display back cover.
