Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug cpu-traffic-stats

Enable the collection of computer processor unit (CPU) traffic statistics.

Syntax

debug cpu-traffic-stats

Defaults

Disabled

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

This command enables (and disables) the collection of CPU traffic statistics from the time this command is executed (not from system boot). However, excessive traffic a CPU receives automatically triggers (turn on) the collection of CPU traffic statics.

To view the traffic statistics, use the show cpu-traffic-stats command.

If the CPU receives excessive traffic, traffic is rate controlled.

NOTE: You must enable this command before the show cpu-traffic-stats command displays traffic statistics. Dell Networking recommends disabling debugging ( no debug cpu-traffic-stats) after troubleshooting is complete.

Related Commands

show cpu-traffic-stats— displays the cpu traffic statistics.