Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

virtual-ip

Configure a virtual IP address for the active management interface. You can configure virtual addresses both for IPv4 independently.

Syntax

virtual-ip { ipv4-address}

Parameters

ipv4-address

Enter the IP address of the active management interface in a dotted decimal format (A.B.C.D.).

Defaults

none

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

Each time you issue this command, it replaces the previously configured address of the same family. The no virtual-ip command takes an address/prefix-length argument, so that the desired address only is removed. If you enter the no virtual-ip command without any specified address, the IPv4 virtual addresses are removed.

Example

Dell#virtual-ip 10.11.197.99/16