Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

member

Assign a stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack compatible command in its configuration.

Syntax

member interface

To remove an interface from a Stackable VLAN, use the no member interface command.

Parameters

interface

Enter the following keywords and slot/port or number information:

For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

Defaults

Not configured.

Command Modes

conf-if-vl-<vlan-id>-stack

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

You must enable the stackable VLAN (using the vlan-stack compatible command) on the VLAN prior to adding a member to the VLAN.

Related Commands

vlan-stack compatible — enables stackable VLAN on a VLAN.