Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

router-id

Designate a fixed router ID.

Syntax

router-id ip-address

To return to the previous router ID, use the no router-id ip-address command.

Parameters

ip-address

Enter the router ID in the dotted decimal format.

Defaults

The router ID is selected automatically from the set of IPv4 addresses configured on a router.

Command Modes

ROUTER OSPFv3 for OSPFv3

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Added support for OSPFv3.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

You can configure an arbitrary value in the IP address for each router. However, each router ID must be unique.

If this command is used on an OSPFv3 process that is already active (has neighbors), all the neighbor adjacencies are brought down immediately and new sessions are initiated with the new router ID.

Example

Dell(conf)#router ospf 100
                                             Dell(conf-router_ospf)#router-id 1.1.1.1
                                             Changing router-id will bring down existing OSPF adjacency [y/n]:
                                             
                                             Dell(conf-router_ospf)#show config
                                             !
                                             router ospf 100
                                             router-id 1.1.1.1
                                             Dell(conf-router_ospf)#no router-id
                                             Changing router-id will bring down existing OSPF adjacency [y/n]:
                                             Dell#