Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show system stack-unit stack-group

Displays the stack-groups present/configured for a FN I/O Aggregator stack unit.

Syntax

show system stack-unit unit-number stack-group [configured]

Parameters

unit number <0–5>

Enter the number of the member stack unit. The range is from 0 to 5.

Defaults

none

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.6.(0.0)	Supported on the FN I/O Aggregator.

Usage Information

This command is supported on the M I/O, FN410S, and FN410T Aggregators.

Example

Dell#show system stack-unit 0 stack-group ?
                                             configured        Configured stack groups
                                             |                 Pipe through a command
                                             <cr>
                                             Dell#show system stack-unit 0 stack-group configured
                                             Configured stack groups in stack-unit 0
                                             Dell#show system stack-unit 0 stack-group
                                             Stack group Ports
                                             ------------------------------------
                                             0            0/9
                                             1            0/10
                                             2            0/11
                                             3            0/12
                                             Dell#

Related Commands

reload— reboots the system.

show system— displays the current status of all stack members or a specific member.