Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Enable boot support

Steps

  1. Enter the Dell PERC 11 Configuration Utility. See Navigate to Dell PERC 11 configuration utility.
  2. Click Main Menu > Controller Management.
  3. From the Select Boot Device drop-down box, select the primary bootable device.

    In Select Boot Device, you will not be able to view 4 K sector drives. To view all the virtual disks created, navigate to the Virtual Disk Management screen in HII. For more information, see Virtual disk management.

    If no boot device is selected, the first virtual disk will be set as the boot device on the next reboot. A Non–RAID disk is auto-selected as the boot device, if the controller does not have any virtual disks present.

    NOTE:Select Boot Device is only applicable in legacy BIOS mode.
    NOTE:4 K sector drives boot support is only available in UEFI mode and managed by the boot loader.
  4. Click Apply Changes.
    Boot support is enabled for the selected controller.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\