Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Physical disk erase

Prerequisites

To use the Physical Disk Erase feature from the HII Configuration Utility, perform the following steps:

Steps

  1. Enter the Dell PERC 11 Configuration Utility. See Navigate to Dell PERC 11 configuration utility.
  2. Click Main Menu > Physical Disk Management.
    The list of physical disks is displayed.
  3. Select a physical disk.
  4. From the Operations drop-down menu, select Physical Disk Erase.
    NOTE:If the drive installed is neither SED or ISE capable, then only the Physical Disk Erase option is displayed.
  5. Click Go.
    A screen is displayed asking if you are sure you want to perform the operation.
  6. Select the Confirm option.
  7. Click Yes.
    The physical disk erase operation is completed successfully.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\