Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Install PERC 11 driver on which the Windows Server 2016 is already installed and later

About this task

Perform the following steps to configure the driver for the RAID controller on which the Windows Server 2016 is already installed:

Steps

  1. Turn off the system.
  2. Install the new RAID controller in the system.
    For detailed instructions on installing the RAID controller in the system, see Install and remove a PERC 11 card.
  3. Turn on the system.
    The Found New Hardware Wizard screen displays the detected hardware device.
  4. Click Next.
  5. On the Locate device driver screen, select Search for a suitable driver for my device and click Next.
  6. Browse and select the drivers from the Locate Driver Files screen.
  7. Click Next.
    The wizard detects and installs the appropriate device drivers for the new RAID controller.
  8. Click Finish to complete the installation.
  9. Reboot the system when prompted.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\