Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series
Remove the PERC H355 adapter SAS
Describes the tasks to remove a PERC H355 adapter SAS controller from a server.
Prerequisites
CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
NOTE:It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
Steps
- Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
- Open the system.
- Locate the PERC card in the expansion riser on the system board.
CAUTION:To prevent damage to the card, you must hold the card by its edges only.
- Unfasten and lift the riser from the system board. Remove the PERC card.
- Disconnect any SAS cables connected to the card:
- Press down and hold the metal tab on the SAS cable connector.
- Pull the SAS cable out of the connector.
- Replace the storage controller and reconnect the SAS cable before placing them in the riser. For more information on installing the card, see Install the PERC H355 adapter.
- Reinstall the riser on the system board and fasten the riser.
- Close the system.
- Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Figure 1. Remove the PERC H355 adapter SAS 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\