Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Install PERC H350 Mini Monolithic SAS

Prerequisites

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Angle the integrated storage controller card and align the end of the card with the storage controller card connector on the system board.
  2. Lower the connector side of the storage controller card into the storage controller card connector on the system board.
    NOTE:Ensure that the slots on the system board align with the screw holes on the storage controller card connector.
    Figure 1. Install PERC H350 Mini Monolithic SAS
    Install PERC H350 Mini Monolithic SAS
  3. Route the storage controller card cable along with the wall of the system.
  4. Align the screws on the integrated storage controller card cable with the screw holes on the connector.
  5. Using Phillips #2 screwdriver, tighten the screws to secure the integrated storage controller card cable to the card connector on the system board.
    Figure 2. Install the cable
    Install the cable

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\