Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

PDF

Remove the PERC H755 adapter

Prerequisites

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE:It is recommended that you always use a static mat and static strap while working on components in the interior of the system.

Steps

  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    NOTE:Perform a graceful shutdown of the system to ensure data in the cache is moved to the disk before the controller is removed.
  2. Open the system.
  3. Locate the PERC card in the expansion riser on the system board.
    CAUTION:To prevent damage to the card, you must hold the card by its edges only.
  4. Unfasten and lift the riser from the system board. Remove the PERC card.
  5. Disconnect any cables connected to the card:
    1. Press down and hold the metal tab on the cable connector.
    2. Pull the cable out of the connector.
  6. Replace the storage controller card and reconnect the data cables before placing them in the riser. For more information on installing the card, see Install PERC H755 adapter.
  7. Reinstall the riser on the system board and fasten the riser.
  8. Close the system.
  9. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
    Figure 1. Remove the PERC H755 adapter. This image shows how to remove a PERC H755 adapter.
    This image shows how to remove a PERC H755 adapter.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\