Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products

Dell PowerEdge RAID Controller 11 User’s Guide PERC H755, H750, H355, and H350 Controller Series

Remove PERC H350 Mini Monolithic SAS

Prerequisites

CAUTION:Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Using Phillips #2 screwdriver, loosen the screws that secure the storage controller cable to the connector on the system board.
  2. Lift the storage controller cable to disconnect it from the connector on the system board.
    Figure 1. Remove the cable
    Remove PERC H350 Mini Monolithic SAS
  3. Lift one end of the card and angle it to disengage the card from the card holder on the system board.
  4. Lift the card out of the system.
    Figure 2. Remove the PERC H350 Mini Monolithic SAS
    Remove PERC H350 Mini Monolithic SAS

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\